Release Highlights
Release Module Enhancements 5.0-2 I/O Tasks afdxasyncio - Add internal CAN hardware variables to monitor CAN message output schedule rate etc. canasyncio - Add support to run under 64 bit. Add internal CAN hardware variables to monitor CAN message output schedule rate etc. Change schedule TX of CAN messages from board implementation/API to software timing as in afdxasyncio and arinc429asyncio. All corresponding API calls have been added to allow for control of TX rates/modes, etc. New session start/stop/pause buttons in the global toolbar.
lcaioin - Add support for single ended inputs. In SE mode, the number of input channels is 32.MATLAB/Simulink ignore FromWs block in Signal Builder Blocks during RTDB creation and check compliance. Convert sample time of Inf to -1 for const blocks since SimWB does not under stand Inf.
Add underscore in front of subsystem and block names to make them into a C compliant structure. This take care of the issue when block names are C keywords like double, const etc.SimWB API Change schedule TX of CAN messages from board implementation/API to software timing as in afdxasyncio and arinc429asyncio. All corresponding API calls have been added to allow for control of TX rates/modes, etc. SimWB Core Add service call gethardwarevars to get the list of internal variables from the selected RTDB. The hardwarerecord.db file is read and internal variable names are generated from it.
Release Module Enhancements 5.0-1 Control Center New navigation with global toolbar, global command tabs, and local toolbars. New session start/stop/pause buttons in the global toolbar.
New improved tab panels for easier workflow.
Ability to display ALT value in the DLViewer plot.
Improved display speed when displaying a test run with many different rates.
Add refresh button to reload the list of RTDB's. Add support for default value for array items.
Add refresh button to reload the list of tests.Data logger Improved tag creation heuristics always result in a tag. -X option added to specify extracted items on the command line.
-M option added to list only the tag table.
-l option added to make communication of messages to SimWB optional (now off by default, instead of on).
Meta information will now be sent to stdout instead of stderr.I/O Tasks PAS2080 initialization of pulse window latch now deferred one cycle for more accuracy. Toothed wheel bias handling improved to avoid possible hang.
MATLAB/Simulink Enhanced support for nested model referenced models. Support added for non-virtual buses in MATLAB R2010a and later.
Support added for propagating constant block values as RTDB variable default values for Constant blocks mapping to RTDB variables in R2010a and later.
New hierarchical structure for RTDB variables created from the SimWB Toolkit.
New regular expression support for automatic RTDB creation.SimWB Core Support added for default value of array items. New generic multirate scheduler added to SimWB.