Installation
Instructions for installing SIMulation Workbench are provided below:
Contents
Prerequisites
Required Software
- RedHawk® Linux Version 4.1 and later 32-bit or 64-bit operating system
- RedHawk® Linux Frequency-Based Scheduler (FBS)
- Concurrent NSLM licenses for SIMulation Workbench® and SIMulation Workbench licenses
Optional Software
- MATLAB®/Simulink®
Hardware
- Any Concurrent iHawk® or ImaGen® system
- Real-Time Clock and Interrupt Module (RCIM)
Installing SIMulation Workbench real-time host
Follow the steps below to install SIMulation Workbench on the RedHawk Linux real-time host system:
- With RedHawk Linux Version 4.1 or later running, log in as root and take the system down to single-user mode:
- Right click on the desktop and select Open Terminal.
- At the system prompt, type
[RedHawk]# init 1
- Insert the Simulation Workbench installation disc into the CD-ROM drive.
- To mount the cdrom device, execute the following command:
[RedHawk]# mount /media/cdrom
- To install, execute the following commands:
[RedHawk]# cd /media/cdrom [RedHawk]# ./install-simwb
- When the installation completes, execute the following commands:
[RedHawk]# cd .. [RedHawk]# umount /media/cdrom [RedHawk]# eject
- Remove the disc from the CD-ROM drive and store. Exit single-user mode (Ctrl+D).
The SimWB server services will start automatically after being installed. Note that the following command can be used to stop, start, and restart these SimWB services:
[RedHawk]# /etc/init.d/simwb stop|start|restart
The SimWB software is always installed in the /usr/local/ccursim directory.