:This option specifies mapping source and sink blocks with "SW" prefixing in the block names to RTDB variables. The RTDB variables have the same name as the blocks. This option is useful if you want only a few source and sink blocks in your Simulink model to map to RTDB variables. This option is also useful for mapping blocks which are not supported by the Using Block Names option to RTDB variables. For example if you have Signal Builder block and you want to associate it with the RTDB variable long_moment, then rename the Signal Builder block to SWlong_moment. The RTDB variable will be saved without the "SW" prefix as long_moment. Only blocks with "SW" prefix will be mapped to their corresponding RTDB variables. Using this option, inports and outports with the SW prefix are picked up irrespective of which subsystem they are in within the model.
+
:This option specifies mapping source and sink blocks with "SW" prefixing in the block names to RTDB variables. The RTDB variables have the same name as the blocks. This option is useful if you want only a few source and sink blocks in your Simulink model to map to RTDB variables. This option is also useful for mapping blocks which are not supported by the Using Block Names option to RTDB variables. For example if you have Signal Builder block and you want to associate it with the RTDB variable long_moment, then rename the Signal Builder block to SWlong_moment. The RTDB variable will be saved as SWlong_moment. Only blocks with "SW" prefix will be mapped to their corresponding RTDB variables. Using this option, inports and outports with the SW prefix are picked up irrespective of which subsystem they are in within the model.